Yokomo YOKB2-415R Rear Hub Carrier for B-Max-2  [YOKB2-415R]

Rear hub carrier for B-Max-2

The Yokomo YOKB2-415R is a replacement rear hub carrier designed for the B-Max-2 1/10 touring chassis. As a direct service component it serves the rear upright area of the chassis, providing the interface between the wheel hub and the rear suspension assembly.

Fit and installation: this part is intended to replace the factory rear hub carrier on a B-Max-2 chassis without modifying the surrounding assemblies. When installing, verify alignment of the hub carrier to the rear upright and confirm all mounting holes and fasteners match the chassis points; use the correct hex driver and standard RC workshop practice. Avoid overtightening and inspect thread condition before final assembly.

Tuning role: swapping hub carriers is commonly used to restore geometry after wear or damage and to change the feel of the rear end by altering mounting points or offsets if alternate carriers are available for the B-Max-2. In track setups the hub carrier influences camber and toe behavior, so consider small adjustments and test runs after replacement.

Maintenance notes: check the hub carrier for wear or deformation during service intervals, inspect associated ball bearings and wheel hexes for play, and replace worn hardware as needed. Clean mating surfaces and remove debris before reassembly to ensure repeatable alignment.