Yokomo YOKB4-200FBG Graphite Front Brace for B-Max4III  [YOKB4-200FBG]

This is an RC-scale graphite front brace produced by Yokomo for the B-Max4III chassis, intended to stiffen the front section of the chassis to influence handling balance during track tuning. The component is described as a front brace and is used to change how the front end responds to steering inputs and surface variations.

Fitment: the part name identifies it for the B-Max4III platform, so installation targets that chassis layout and mounting points. No additional adapters are assumed; verify hole alignment on your existing front bulkhead before fitting to avoid unwanted stress on mounting screws or the chassis.

Installation notes: use the factory mounting hardware or matching-diameter screws, tighten incrementally and check preload to prevent overtightening on composite or molded sections. As with other hop-ups, test small adjustments on-track to evaluate how added front stiffness alters understeer and transient turn-in.

Maintenance and care: being a graphite component, avoid impact against hard obstacles and inspect for hairline cracks after crashes. Clean with a soft brush and mild solvent safe for composites, and recheck fasteners after initial test runs.