Yokomo YOKBM206W - Rod End Plastic Parts (White)  [YOKBM206W]

Rod end plastic parts for R/C linkages

The Yokomo YOKBM206W rod end plastic parts are an RC-scale replacement for tie-rod and turnbuckle connections used in steering and suspension linkages. These white plastic rod ends provide a low-profile connection point where a ball end or turnbuckle meets the linkage, intended for general R/C tie-rod systems rather than any specific chassis.

Designed as a straightforward service part, the pieces address wear and play that can develop in steering linkages. Plastic rod ends trade the hardness of metal for quiet operation and lower cost, and they are commonly used in applications where reduced binding and lighter weight are preferred. Expect typical plastic characteristics: adequate wear life for hobby use and some flex compared with metal alternatives.

Installation is direct: remove the worn rod end from the turnbuckle or linkage, fit the replacement so the ball-seat engages cleanly, and confirm free movement through the linkage travel. After installation, inspect the joint for excessive play and perform a final steering centring check. Because this product fits general tie-rod and turnbuckle configurations, verify thread sizes and ball-seat type on your car before use to ensure a correct fit.

For tuning, plastic rod ends influence steering feedback and compliance; swapping to a stiffer material or a metal rod end is one common way to reduce flex if tighter steering response is needed. Conversely, plastic rod ends can help absorb minor impacts and reduce transmitted shock to servo linkages in casual or practice settings.