Yokomo YOKD170BL Soft Blue 1.1 x 10.5 Turns Standard Drift Spring Set (2pcs)  [YOKD170BL]

Standard Drift Spring for Tuning

This RC-scale spring set is aimed at standard drift setups where small changes in spring behavior alter slide and steering feel. The soft blue springs are specified as 1.1 x 10.5 turns and are supplied as 2 pcs, intended for use in typical drift shock assemblies on 1/10 scale models.

Installation is straightforward: fit the springs over the shock shaft or spring cup following your shock manufacturer's orientation, use appropriate spring preload collars if needed, and check travel to avoid binding. These springs influence how quickly a tyre regains traction after a slide and how the chassis rotates into a corner.

Tuning notes: softer spring rate like this soft blue profile tends to increase slip and promote smoother transitions between drift angles, while reducing abrupt snap-back. Use them to balance front and rear response, adjust preload incrementally, and pair with tyre choice and ride height changes for predictable results.