Yokomo YOKDRR413A1 Aluminum Front Steering Hub Carrier Caster 10 degree Red  [YOKDRR413A1]

Aluminum front steering hub carrier, 10° caster

This RC-scale aluminum front steering hub carrier provides a fixed 10 degree caster offset in a red finish, intended as a direct replacement or upgrade for compatible front steering assemblies where a 10° caster hub is required. The part is machined from aluminum to improve rigidity compared with typical plastic carriers and to keep steering geometry stable under load.

Installation is straightforward for experienced builders: remove the stock front hub carrier, transfer any needed wheel hex, bearings, and fasteners, and mount this carrier using the original mounting points. After installation, confirm steering throw and toe settings, and check for binding across the full suspension travel.

In tuning, a 10 degree caster hub like this shifts the static caster versus a lower-angle hub, which affects straight-line stability and self-centering steering feel. Use it when you want a predictable increase in steering return and high-speed stability while monitoring changes to turn-in and tire wear.

This hub carrier is a practical aluminum option for builders seeking a consistent 10° caster setting in the front end, provided the mounting points and steering components match the carrier geometry; always verify fitment before final runs.