Yokomo YOKRP-012 Racing Performer 200mm Sensor Wire for RP — Brushless motor sensor lead  [YOKRP-012]

200mm sensor wire for RP

The Yokomo YOKRP-012 Racing Performer sensor wire provides a straightforward replacement or extension lead for RP-series sensor-equipped brushless setups. At 200mm, the lead is intended for internal wiring runs between a sensor-equipped motor and an ESC or junction, giving a measured length for tidy routing inside touring, drift, or competition-scale electric cars.

Use this wire when replacing a damaged sensor lead or when you need a consistent length for repeatable installation and tuning. Keep the wire separate from high-current power lines to reduce interference, secure routing with small ties or clips, and avoid tight bends near solder joints. For best signal integrity, shorten excess length only after confirming final component placement.

Installation notes: route the lead along existing chassis channels where possible, use heat-shrink over soldered joins to prevent shorts, and verify connector orientation before final assembly. The wire serves a passive wiring role and does not change electronic timing or motor parameters by itself, but reliable sensor connections are essential for smooth commutation in sensor-equipped brushless motors.