Yokomo YOKSD415S10 - Aluminum Front Steering Block (King Pin) Offset 10 Degree for Drift  [YOKSD415S10]

Front steering block for drift

This aluminum front steering block is an RC-scale replacement part designed for drift setups where a 10 degree king pin offset is required to alter front steering geometry. The component focuses on the steering pivot position and how it affects steering angle and response in drift tuning.

Intended use is strictly within RC drift applications, and the block is a tuning component rather than a complete steering assembly. Installation replaces the existing front steering block or king pin carrier on compatible drift hubs using the vehicle's original fasteners, and alignment checks are recommended after fitting to confirm king pin orientation and wheel toe.

In tuning terms, a 10 degree king pin offset shifts the steering pivot relative to the wheel plane, which can increase steering angle and change self-centering behaviour; adjustments to toe and steering link geometry may be needed to optimise handling for specific drift setups.

As a focused tuning part, this aluminum steering block offers a defined 10 degree king pin offset for drivers refining front-end behaviour on RC drift chassis, and should be paired with careful alignment and setup adjustments.