Yokomo YOKSG-A4882 - DCS 82T Spur Gear (DP48)  [YOKSG-A4882]

Spur gear role and fit for DP48

This RC-scale spur gear is specified as an 82-tooth unit labeled DCS for DP48 application, provided as a direct replacement part for spur gear assemblies. It is intended for users who need to restore correct mesh, change gear ratios, or replace a worn spur in RC model drivetrains.

Installation is straightforward for typical touring-style gearboxes that accept DP48-design spur gears: confirm centre mesh, check backlash with the motor pinion, and secure the gear per your chassis' original retaining method. Use proper run-in and verify smooth rotation under load before finalizing setup.

Tuning role: changing to this 82T spur alters gearing and can be used to refine acceleration versus top speed depending on the motor and pinion selected. When swapping spur sizes, re-check mesh, pinion alignment, and ensure bearings and lay shaft rotate freely to avoid premature wear.

• Tip: When fitting, rotate the drivetrain manually to confirm no binding, then test at low power to verify clearance.
• Tip: Match the spur with compatible pinion tooth counts to reach desired gear ratio without exceeding motor specifications.