Yokomo YOKZCTB27 - Titanium Turnbuckle (27mm) 2pcs  [YOKZCTB27]

Titanium turnbuckle for 1/10 scale RC

This is a pair of 27mm titanium turnbuckles designed as RC-scale tie-rod links for steering and suspension adjustment. Supplied as 2 pcs, the turnbuckles serve as adjustable linkages between ball ends and rod ends to fine-tune toe, camber correction link geometry, and steering throw without replacing fixed-length rods.

Installation is straightforward for hobbyists familiar with standard turnbuckle links: remove the existing link, match left- and right-hand thread orientation, screw in until the nominal length is reached, then fine-adjust both ends to equal thread engagement. Secure any locking hardware on your existing ends and verify free travel through the steering knuckles and suspension pickup points before test runs.

Tuning role: use the adjusted length to dial in small toe-in or toe-out changes, correct minor asymmetries, or trim steering centering. Titanium construction reduces weight at the outer linkage and resists corrosion, which helps maintain consistent geometry over time. Inspect ball cups and mating hardware for wear and compatibility before use, and perform a final check after the first on-track session.