Yokomo YT-303 8mm Steel Turnbuckle Wrench for 1/10 RC  [YT-303]

Yokomo YT-303 Steel Wrench (8mm)
Price:
USD$10.60
Brand:
Yokomo
Model:
YT-303
GTIN:
639342230655
Condition:
Brand New
Write a review

Compact 8mm steel wrench for turnbuckle adjustments

This 8mm steel wrench is built as an RC-scale setup tool for turnbuckles, rod ends and small nuts commonly used on 1/10 touring and drift chassis. Its fixed 8mm face helps maintain proper contact on hex flats during fine suspension and toe adjustments.

Use-case notes: the wrench is intended for setup and maintenance tasks such as adjusting tie-rods, correcting toe-in/out, and trimming minor alignment differences after chassis changes. Support the link or opposite nut while turning to isolate torque and avoid twisting suspension components.

Care and handling: clean the contact faces after sessions and store in a tool pouch to prevent loss. Regular inspection for burrs or deformation keeps engagement accurate. This item is an RC accessory for chassis setup, not for full-size vehicle use.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Which chassis types is this wrench suitable for?

Fits standard 8mm turnbuckle nuts commonly found on 1/10 touring and drift chassis and many similar 1/10 scale models.

How should I store and maintain the wrench?

Keep it in a tool pouch, wipe clean after use, and check for burrs. Avoid using excessive torque to prevent deforming small nuts.

Can this replace adjustable pliers for setup work?

It complements pliers; use the wrench for direct nut engagement and pliers only when additional holding or leverage is required.

Copyright © 2008-2026 rcjaz.com All rights reserved