Yokomo YZ-017GW1 Graphite Front Shock Tower (3.5mm) for Works'91 TeamSpec  [YZ-017GW1]

Graphite front shock tower details

The Yokomo YZ-017GW1 front shock tower is a dedicated 3.5mm graphite replacement part designed for the Works'91 TeamSpec platform. As an RC-scale accessory, the plate stabilizes damper movement and provides a firmer mounting point for upper shock mounts, helping maintain consistent front suspension geometry during aggressive cornering and braking on track.

This tower is intended for hobbyists who tune front-end response. Its 3.5mm graphite construction balances stiffness and weight, yielding crisper shock actions without adding unnecessary mass to the chassis. The part is shaped to accept standard upper shock mounting positions used on the supported YZ-W91TS and YZ-W91 layouts, allowing direct swap with the factory piece.

Installation notes: the tower mounts to the existing shock tower posts and uses the same fasteners as the original board, so no extra hardware is required when replacing like-for-like. During setup changes, riders can use the tower as part of a tuning sequence to alter front roll center and shock leverage by selecting different upper mount holes and adjusting shock length or spring rate.

Compatibility

• YZ-W91TS
• YZ-W91

Use this graphite tower when seeking firmer front-end feel and more predictable shock behavior on Works'91 TeamSpec chassis, especially during setup changes focused on turn-in and mid-corner balance.