Yokomo Z2-017D Front Shock Tower for YZ-2DT replacement part  [Z2-017D]

Front shock tower for YZ-2DT

This is an RC-scale front shock tower intended as a replacement or spare for Yokomo's YZ-2DT 2WD off-road chassis line. It provides the mounting point for the front shocks and is used in setup work where suspension geometry or shock mounting position needs to be restored or changed.

Compatibility covers the YZ-2DT family as listed below, preserving the exact chassis codes. Use this part when a damaged tower needs replacing or when reverting to stock geometry during setup iterations.

• B-YZ2DT
• B-YZ2CA
• B-YZ2DTM
• B-YZ2DTMW
• B-YZ2DTM2
• B-YZ2CAL2
• B-YZ2DTM2S
• B-YZ2DTM3
• B-YZ2CAL3

Installation notes: the tower installs at the front bulkhead using the chassis' existing shock tower mounting points. When replacing, remove the old tower, transfer any reusable hardware and verify shock alignment and ride height after reassembly. For precise torque values or screw sizes refer to the chassis manual or the original manufacturer guidance rather than assuming alternate hardware.

Tuning role: as the structural mount for the front shocks, the tower directly affects suspension geometry and tuning options. Swapping towers is commonly done to restore correct mounting locations or to return to a known baseline during setup changes, helping to evaluate shock positions, camber behavior and front-end response.