Yokomo Z2-18841 MIP Pucks Bi-metal dogbone 67mm for YZ-2 Stock ver. — Bi-metal dogbone set for YZ-2 Stock MIP Pucks drive system  [Z2-18841]

MIP Pucks 雙金屬狗骨配件

The Yokomo Z2-18841 is a pair of bi-metal universal dogbones intended for the MIP Pucks drive system used on YZ-2 Stock ver. chassis. This RC-scale accessory supplies direct replacements for the stock dogbone position, delivered as two sets to cover both sides of the drivetrain. The component is explicitly produced for the YZ-2 Stock MIP Pucks arrangement, and its bi-metal construction targets a balance between wear resistance and drivetrain feel without altering the chassis geometry.

Fit and function are focused: these dogbones interface with the MIP Pucks couplers and stock differential outputs on supported YZ-2 variants. Installation requires basic disassembly of the center drives and verification of pucks alignment; no additional adapters are listed or required. When replacing existing dogbones, inspect the MIP Pucks for wear and confirm runout is within your usual setup tolerances to prevent accelerated wear on the bi-metal surfaces.

From a tuning perspective, the Z2-18841 parts serve as maintenance and durability items rather than a radical performance upgrade. Drivers using them should treat the pieces as serviceable wear items and monitor contact points, especially under high-traction track conditions. Because these parts are for the MIP Pucks system, they are relevant to setups that retain the stock YZ-2 Stock driveline layout.

Use these dogbones when restoring original MIP Pucks driveline function or as replacement wear parts during routine maintenance, and verify puck alignment and retaining hardware after installation to maintain drivetrain reliability.