This spacer is an RC-scale regulator accessory intended to position and secure a regulator unit on FZ115S-compatible setups. It serves as a simple mechanical interface between the regulator and the engine mount area, keeping alignment and spacing consistent during tuning and trim.
The part is described and supplied as a single spacer element, not a complete regulator assembly. Its role is to correct clearance and alignment where the regulator body and mounting points require an intermediate thickness to avoid contact with surrounding components such as mounts, brackets, or air-cooling shrouds.
Installation is straightforward for experienced model technicians: remove the regulator mounting screws, insert the spacer between the regulator flange and the mounting surface, then refit screws and verify alignment. Check that the regulator linkage and any fuel or vent tubing remain free and that the spacer does not impose torsion on mounting fasteners.
In tuning contexts the spacer can be used to fine-tune regulator placement to achieve consistent fuel flow and stable mounting under vibration. It is suitable for model glow engine setups where small positional adjustments of the regulator improve access or clearances without modifying the mount or regulator body.
Copyright © 2008-2026 rcjaz.com All rights reserved
